D-Robotics 29927 RDK PoE Module

Artnr.: WS1-029927
Hersteller: D-Robotics

Power over Ethernet Expansion Board For RDK X5, Onboard Cooling Fan, With Metal Heatsink, Supports 802.3af/at Network Standard

21,90 €

inkl. 19% MwSt.

(18,40 € exkl. MwSt.)

zzgl.

ab Lager lieferbar
Lieferzeit: 1 - 3 Arbeitstage (DE - Ausland abweichend)

Beschreibung
Kundenrezensionen

PoE Expansion Board For RDK X5

Suitable For D-Robotics RDK X5 Development Board, Supports 802.3af/at Network Standard

Onboard 5V and 12V power outputs to meet the needs of more peripherals

Features

This is a 802.3af/at-compliant Power Over Ethernet accessory for the RDK X5 development board. By using this module and some proper 802.3af/at-compliant power sourcing equipments, it is possible to provide both network connection and power supply for your RDK X5 in only one Ethernet cable.

Standard 40PIN GPIO header, suitable for D-Robotics RDK X5 development board
PoE (Power Over Ethernet) capability,IEEE 802.3af/at-compliant
Fully isolated switched-mode power supply (SMPS)
Onboard high speed active cooling fan, with metal heatsink, better heat dissipation

Specifications

PoE power input	38V~57V DC in
Power output	GPIO header 5V 4.5A (MAX)
Power output	2pin header 12V 2A (MAX)
Outline dimensions	56.5 × 70.0 (mm)
network standard	IEEE 802.3af/at PoE

Suitable for RDK X5 development board

Standard RDK X5 40PIN GPIO stackable header, allows connecting other expansion boards

Power Over Ethernet

providing both network connection and power supply for your RDK X5 in one cable

* for reference only, the RDK X5 and switch are NOT included.

Onboard 5V & 12V header outputs

5V header provides up to 4.5A output (MAX 25W for 12V+5V total output power)be able to power extra devices while providing stable power to RDK X5

Onboard active cooling fan

Accelerates Cooling Effect, More Stable Performance

Onboard high-power buck chip

Incorporates the original voltage buck chip, providing up to 5A under sufficient heat dissipation condition

Installation Introduction

Install the metal heatsink on the development board first, and then use the screws in the package to secure the PoE expansion board as shown in the picture below